Warning
If you wish to control your Somfy RTS motorized gate via radio from the monitor, you must register the radio control before installing the monitor (the monitor must then be linked to the motorized gate through its power supply) or activate the button on the motorized gate, depending on the model.
Refer to the Registration of the motorized gate in the monitor's memory FAQ.
1) Attach the monitor mounting plate to the wall.
Important: The monitor's mounting brackets must extend towards you.
Note: All wires must be routed through the mounting bracket to connect to the monitor.
2) Connect the power supply connector on the back of the monitor to terminal block 7-1. The direction for the connection of the power supply wires is important.
Important: Use the power supply provided to power the monitor.
Note: You can use an optional DIN rail-compatible power supply (ref . 9026469).
Important: Do not plug the power supply into an outlet or turn on the DIN power breaker until all wiring is complete (outdoor panel, additional monitor).
3) Plug in the second connector supplied into terminal block 7-2. The corresponding cable will be plugged into the outdoor panel. Optional: Plug a third connector into terminal block 7-3. The corresponding cable will be plugged into a second monitor (see the manual for the additional monitor).
Note: Place the wires in the slots provided to prevent them from being pulled out.
Note: Locate the wires used for terminals 7-2 and 7-3 to correctly wire the outdoor panel and (optional) additional monitor.
4) Clip the monitor onto the mounting bracket by gently sliding it down until its pegs are securely locked into the monitor's notches.